Your search for inorganic binders resulted in 8 matches...
The article gives the results obtained in a fragment of the studies, carried out under a statutory activity, on optimising of the foundry sand technology with new modified inorganic binders, chemically bonded and C...
more >>
The article presents results of an investigation which constitutes a section of research under the project POIG.01.01.02-00-015/09 "Advanced materials and technologies", one of the aims which is the introduction of new ecological inorganic binders...
more >>
One of the factors which influence development tendencies within the scope of moulding sands used in foundry practice is environmental protection. Hence, while assessing technologies, the composition of utilised materials and emissions of harmful ...
more >>
The article presents the results of preliminary studies on the possible application of innovative activation treatments of inorganic binders during the reclamation of waste water glass moulding sands hardened by conventional drying. The test mould...
more >>
The article presents the results of tests and studies carried out within the framework of statutory activities on various additives to moulding sands based on water-soluble inorganic binders for ablative knocking out of castings. As a result of te...
more >>
An attempt has been made to determine the effect of the addition of an agent wetting the surface of silica sand grains, introduced in order to increase the hardening efficiency of selected physical methods applied to the ecological foundry sands b...
more >>
Protective coatings are applied in order to obtain casts with an even surface, without faults. Protective coatings can contain a solvent based on water or alcohol; however, due to their harmfulness, it is recommended to limit the use of alcohol co...
more >>
The study attempts to complement the information on the effect of the density of moulding sands with inorganic binders on basic strength parameters, i.e. the tensile and bending strength of moulding sands with hydrated sodium silicate, after the p...
more >>
|